Eaton's IS AER FMC division is currently seeking a Sub-Assembly.

The hours for this role are 3:30pm-12am

The hourly rate for this position is $26.23 per hour.

Please note the salary information shown above is a general guideline only. Salaries are based upon candidate skills, experience, and qualifications, as well as market and business considerations.

What you'll do:

KEY ACCOUNTABILITIES:

• Responsible for minor assembly processes, such as rotor/shaft assembly, pressure plates assembly, and shaft seal assembly, as required by work orders and/or lean line operations.
• Responsible for the creation, production, and attachment of all production and R.E.O. nameplates in accordance with the requirements designated on the case history and/or the Sales Order Addendum. The production of nameplates shall be accomplished using all of the designated processes and equipment located in the area.
• Responsible for lock wiring all units in accordance with all specifications defined by the customer, by prints, and by case histories. The individual shall also be responsible for physically re-checking and validating all fastener torque requirements as required.
• Responsible for visually inspecting and completing final unit pre-shipment operations such as installation of drive shafts, o-rings, caps, plugs, placement of lock wire "tamper seals", etc.
• Responsible for masking off and painting parts and units while following blueprints and special paint processes according to customer requirements and specifications.
• Completes all required quality and customer information on reports and documents.
• Responsible for self-inspection and verification of same on all required assembly and test documentation.
• Responsible for maintaining cleanliness and order in all assigned working areas to the highest degree of cleanliness required for ensuring the highest quality standards in the assembly of all products.
• Responsible for safety for self and for other employees in the area.
• Ability to read and complete inspection ledger, inspection check sheet, operation sheet,
• move ticket and discrepancy report (DR) and other paperwork as necessary to comply with Quality Systems.
• Responsible for notifying supervisors when work received does not meet the specifications required by previous operators including paperwork requirements as observable.
• Performs operator defined 5S/TPM tasks as required.
• Responsible for returning all tools to their proper location at the end of the shift and cleaning work area.
• Proper use of all tools and gages necessary to complete and to verify that all work performed has been completed to specifications as required.
• Subassembly operations such as, installation of pins, plugs, inserts, bearings, miscellaneous components, etc.
• Performs minor sanding, lapping, deburr or repair work as required in the course of
• performing the primary duties of the classification.
• Compliance to Manufacturing Self-Release Process (MSRP) and responsible for the quality of the product going to next operation.
• Other duties as required or assigned within the job classification.

• Team player attitude demonstrated in boss and peer relationships in a diverse
• environment
• Strong work ethic demonstrated through action orientation and a drive to achieve results
• Great mechanical aptitude along with excellent problem solving skills
• Good writing skills and ability to comprehend detailed written instructions
• High degree of manual dexterity for complex assembly
• Ability to read blueprints and applicable specifications
• Basic knowledge of component parts
• Basic computer skills required including the ability to access and save files

• Prior work experience with hydraulic systems in an aviation or military setting
• Ability to read and follow quality procedures
• Prior work experience following documented process plans and procedures

• High school diploma or GED required
• Two (2) years general manufacturing or military experience required
• This position requires use of information or access to hardware which is subject to the
• International Traffic in Arms Regulations (ITAR). All applicants must be U.S. persons within the meaning of ITAR. ITAR defines a U.S. person as a U.S. Citizen, U.S. Permanent
• Resident (i.e. 'Green Card Holder'), Political Asylee, or Refugee
• No relocation benefits are being offered for this position. Only candidates residing within
• 100 miles of Eaton's Jackson, MS facility will be considered for this position